superheated steam heating Many 3 pass pellet boiler-pls 90 saturated steam heating. When using saturated steam heat, you need to set traps along the steam pipes. Traps because of the quality and regulation management issues, a large amount of leakage of steam, causing a great waste of energy. We take reconstruction measures will increase the steam boiler superheater, saturated steam superheater 20%. To use before the steam heating equipment for the micro superheated steam. Thereby eliminating the trap along the way, to eliminate the hydrophobic and run steam brings heat loss. This is closely related to the size of the heat loss and management level of the factory. Well managed, only hydrophobic heat loss, poor management, there are a lot of running steam losses. This loss is typically several percentage points.

Guangdong good gas hot water 3 pass pellet boiler-pls 90 Which companies? At present, the domestic hot water boiler gas suppliers have their own advantages, depending on the load. People do not need to ask questions to determine whether the gas hot water boiler in question. ? What is included in the following professional standards for everyone to detailed analysis by the Henan fast boiler, with a look: In general, in order to accurately choose our gas hot water boiler, should be aware of the following issues: First, the gas the thermal efficiency of the boiler water; two, gas hot water boiler starts output speed; third, the rated load of the gas hot water boiler; four navigation, gas hot water boiler

It provides fast side of 3 pass pellet boiler-pls 90 equipment, installation and commissioning after all normal, we immediately put into use, the hotel did not delay the normal heating. Meanwhile boiler capacity, energy efficient, fully able to meet the needs of heating and bathing water in our hotel rooms. --customer feedback

The roving inspection system of 3 pass pellet boiler-pls 90 is that the personnel on duty should do their own work well, check the equipment under their jurisdiction in accordance with the regulations, and carefully check it, and there must not be any omissions. In the process of circuit inspection, once abnormal phenomena are found, the correct measures should be taken to deal with them in time, and the corresponding records should be reported and recorded in time. Check to be comprehensive and meticulous, to understand the operation of the equipment thoroughly, can not be vague and approximate. After completing the work in an all-round way, the report will be able to be carried out. If a defect in the equipment is found, it shall be recorded in the equipment defect record book in a timely manner. For later investigation. To do a good job in succession work, the specific situation is explained in detail.